Configuring Your Own WIFI Network

<< Click to Display Table of Contents >>

Navigation:  Support > Athena Support > Range Equipment > Athena Network Configuration >

Configuring Your Own WIFI Network

If you purchased networking equipment from Scopos with your Athena Order, this is already pre-configured upon provisioning your range before it leaves our warehouses. These steps are intended for Network Admins to design an infrastructure without the need for our pre-configured networking equipment.

If your school or club did not purchase networking equipment from Scopos you are responsible for setting up your own compatable WiFi network. There are three broad steps in doing so, listed below.

1.Configure your WIFI network according to Athena's Network Requirements.
Please note that Scopos support is unable to provide assistance on how to perform this step. Please consult your Network Administer for assistance.

2.Setup your Network Manager.

3.Provide WIFI Credentials to each of your Targets, Monitors, and Displays.

See Also:

Preconfigured WIFI Network