|
<< Click to Display Table of Contents >> Navigation: Support > Athena Support > Electronic Scoring Targets > NC Models > External Interface |
On the back side of the NC Target there are two on / off switches an a button.
The top on / off switch controls the power to the unit.
The bottom on / off switch will run the witness strip (paper roll) motor. To be used when replacing the witness strip or aiming mask. Under normal operation the switch should be in the off position.
Some earlier NC models have a single button on the back of the target, this starts a process that uses the camera to find the alignment shape. More recent NC model targets have a menu interface that allows the user to select more functions and view other pertinent information about the target. This interface includes a screen that allows the user to select information and move positions using the directional control buttons.
The cover that is over the CPU and expansion board is known as the E-Cover. It should always be on.
To remove the cover the power to the unit must be turned off and power cord unplugged. Due to the threat of electro-static discharge (ESD) that could damage the NC Unit's electronics, when removing or replacing the E-Cover make sure to be electrically grounded. Wearing a grounded ESD Band is strongly recommended.